Xbox 360 controller works with ZSNES but not with game

[DisRuptive1]

I'm trying to play Super Mario World. I set the in the Input menu and the program responds fine. However when I go to play the game, the game doesn't respond to any buttons on the controller.

UPDATE: Ok I fixed it by setting "Input #1" to the controller's inputs (it was set to the keyboard with Input 2 set to the controller). So I guess my new issue that the settings I set in "Input 2-5" don't work with the game.

[kode54]

Settings in inputs 2-5 only work if you set the inputs from None to Joypad/Keyboard or whatever the other option is and click Set.

[Gil_Hamilton]

I'm trying to play Super Mario World. I set the in the Input menu and the program responds fine. However when I go to play the game, the game doesn't respond to any buttons on the controller.

UPDATE: Ok I fixed it by setting "Input #1" to the controller's inputs (it was set to the keyboard with Input 2 set to the controller). So I guess my new issue that the settings I set in "Input 2-5" don't work with the game.

Those aren't for alternate control mappings on a single player*.
They designate which SNES gamepad this mapping is for.

Input 1 is the player 1 controller.
Input 2 will be Luigi if you aren't passing the gamepad back and forth.

Inputs 3-5 will never do anything in Super Mario World, as it only supports two controllers.




*Notable exception: If the use P3/4 as P1/2 option is checked, Input 3 and 4 will work as secondary mappings for 1 and 2 instead of as multitap controllers.

[grinvader]

Also note that several games that don't support the multitap will kindly ask you to disconnect any pads plugged in #3-5 before they do anything. Better leave those off unless you're hosting some neat local zbrawl.