ZSNES stops responding when adjusting video

JOEWARE · Post by **JOEWARE** » Sun Jan 02, 2005 4:25 am

I wanna change the video resolution, but after trying to set a resolution, zsnes just "freezes" and stops responding from there and i cannot change the resolution.

snkcube · Post by **snkcube** » Sun Jan 02, 2005 7:12 am

Try changing the resolution by opening .cfg file using Wordpad.

zidanax · Post by **zidanax** » Sun Jan 02, 2005 7:34 am

Also make sure your video card drivers are up to date.

JOEWARE · Post by **JOEWARE** » Mon Jan 17, 2005 2:07 am

It's not my video card. Anyway I found the issue, if i unplug my controller i can adjust the video fine, but when it's plugged it stops responding...

Post by **Nach** » Mon Jan 17, 2005 11:09 am

Does clicking the mouse or pushing a button with your controller work?

JOEWARE · Post by **JOEWARE** » Mon Jan 17, 2005 11:32 pm

Nach wrote:Does clicking the mouse or pushing a button with your controller work?

No... and another thing is that i can't set my second controller, the GUI doesn't hang or anything, but when i tried setting the buttons on the P2 the GUI won't let me click on anything and won't set correctly at all.

Post by **Nach** » Tue Jan 18, 2005 12:03 am

JOEWARE wrote:
Nach wrote:Does clicking the mouse or pushing a button with your controller work?
No... and another thing is that i can't set my second controller, the GUI doesn't hang or anything, but when i tried setting the buttons on the P2 the GUI won't let me click on anything and won't set correctly at all.

Perhaps you should enable the controller before trying to set the buttons?

JOEWARE · Post by **JOEWARE** » Tue Jan 18, 2005 2:48 am

Nach wrote:
JOEWARE wrote:
Nach wrote:Does clicking the mouse or pushing a button with your controller work?
No... and another thing is that i can't set my second controller, the GUI doesn't hang or anything, but when i tried setting the buttons on the P2 the GUI won't let me click on anything and won't set correctly at all.
Perhaps you should enable the controller before trying to set the buttons?

My controllers were already enabled of course. I just had to move the slider up on the 2nd controller for the emulator to detect my controller.