NTSC/PAL

Kay · Post by **Kay** » Thu Aug 12, 2004 12:54 pm

Is there any way to switch from PAL to NTSC on ZSnes, or even change the game speed? Also, this is a small issue, but is it possible to hide all the game information text that comes on in the WIP version whenever you load a new game? Thanks

Post by **Agozer** » Thu Aug 12, 2004 1:41 pm

Check the box for Force PAL / Force NTSC, however forcing a PAL game to go 60Hz is not very wise.

No, you can't disable the rom information tesxt unless you modify the source yourself.

Post by **grinvader** » Thu Aug 12, 2004 1:44 pm

Note that if you wait for the text to disappear *then* reset your game (not load it again, just reset it), you'll have your game intro without text.

You can, as Agozer said, force a timing, but it's likely to cause bad timing bugs.