Paths config stinks

brunodts · Post by **brunodts** » Mon Sep 11, 2006 8:42 pm

Much easier before, copy from adress bar and paste on correct field in"zguicfg.dat" and zsnes reads and writes save states. Now you are forced to use "config - paths", and where the heck is "browse" button? Are we still on dos where you should type letter by letter the path?? Or better - "ctrl + v" shoud work in the gui.

Clements · Post by **Clements** » Mon Sep 11, 2006 8:52 pm

Paths can be entered directly into the zsnesw.cfg file under the Paths section provided you double up the '/'.

brunodts · Post by **brunodts** » Tue Sep 12, 2006 4:58 pm

Yes, i know, but could have a "browse" button or clipboard support.

Deathlike2 · Post by **Deathlike2** » Tue Sep 12, 2006 5:41 pm

brunodts wrote:Yes, i know, but could have a "browse" button or clipboard support.

Clipboard support was thrown around for a bit, but noone has contributed code to add it in.

As for a browse button, that's not out of the realm of impossibilities... it would probably require some work to make this possible. Though, you have to remember this has to be done using the Custom GUI (this isn't your average app after all).

However, this probably isn't a priority as there are more important things than this. This is also not a confirmation that this will be added.. it could be added, but that's it.

Deathlike2 · Post by **Deathlike2** » Wed Oct 11, 2006 2:44 am

Well, there is now clipboard support in SVN... well, at least for pasting anyways. Ctrl+V pastes output to the Paths boxes. You can thank Nach for that.

Firon · Post by **Firon** » Wed Oct 11, 2006 10:53 pm

Thanks for implementing it.