Im' new at Netplay and I'm totally lost
I dont use a hub to connect my network I just simply use a crossover cable.
So how do I go about setting up Netplay
I use crossover cables not a hub plz help
Moderator: ZSNES Mods
-
adventure_of_link
- Locksmith of Hyrule
- Posts: 3634
- Joined: Sun Aug 08, 2004 7:49 am
- Location: 255.255.255.255
- Contact:
read the docs.
if one (or both) computers have a firewall, make sure that port 7845 on TCP and UDP are open.
if one (or both) computers have a firewall, make sure that port 7845 on TCP and UDP are open.
<Nach> so why don't the two of you get your own room and leave us alone with this stupidity of yours?
NSRT here.
NSRT here.
It works just like you're using a router/switch/hub but you'll probably need to assign them static IP addresses and you need to make sure they're using the same speed and duplex (100 mbps full duplex preferable). Get the PC's to recognize eachother from the Network Neighborhood first. The rest will be a cakewalk.
[i]"It is better to have tried and failed than to have failed to try, but the result's the same." - Mike Dennison[/i]